ADDER AdderView CATxIP 000 Betriebsanweisung PDF herunterladen (Seite 21)

 









Using cascaded computers

In use, cascaded computers can be accessed using exactly the same methods as

for those connected directly to the AdderView CATx. However, by far the easiest

way is to use the on screen menu. This is because it displays the computer

names and does not require any knowledge of port addresses, some of which

(as discussed above) can be up to six digits long. See the Selecting cascaded

computers section in the Operation chapter for more details.

Testing specic links to cascaded computers

As mentioned previously, the best and most efcient way to access cascaded

computers is by using the on screen menu and via non-specic routes through

the link groups. However, during conguration or troubleshooting, it may be

useful to test specic routes to computers in order to verify the various strands

of each link group. By using specic port addresses for each unit, rather than

link group numbers, you can precisely navigate a route through any part of the

system.

To test a specic link

1 Simultaneously press and hold and .

Note: and are the standard hotkeys and can be altered to avoid

clashes with other devices or software. If you change the hotkeys, remember

to use the new ones in place of and when following these

instructions.

2 While still holding and , in sequence, press and release the full

address of the required computer – remember to use specic port numbers,

not link group addresses, e.g. 061802, not 424502.

3 When the last digit has been entered, release all keys.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 110 111

Keine Kommentare

ADDER AdderView CATxIP 000 Betriebsanweisung Seite 21